Start-up
7
Installing universal shaft
7.5
EasyCut B 870 CV Collect
Original Operating Instructions 150000707_01_en
47
The road travel lighting is connected by means of the enclosed 7-pin lighting cable (2).
ü
The machine is shut down and safeguarded,
.
Connect the 7-pin plug of the lighting cable (2) to the 7-pin socket (1) of the machine.
Connect the 7-pin plug of the lighting cable (2) to the 7-pin socket (3) of the tractor.
Lay the lighting cable (2) so that it does not touch the tractor wheels.
7.5
Installing universal shaft
WARNING
Risk of injury by failure to take account of the danger zone of the universal shaft
If the danger zone of the universal shaft is ignored, persons can be seriously hurt or killed.
To avoid accidents, observe the danger zone of the universal shaft,
NOTICE
Changing the tractor
The machine could be damaged if the universal shaft length is not checked when changing
the tractor.
In order to avoid damage to the machine, check universal shaft length every time the
tractor is changed and correct it, if necessary,
.
KMG000-048
ü
The machine is shut down and safeguarded,
.
Slide universal shaft (1) on PTO shaft end of tractor and secure it.
Secure universal shaft guard by means of supporting chain (2) against turning.
7.6
Checking the tines on the tine conditioner
NOTICE
Loss of tines
Bent and broken tines will cause an imbalance. Therefore the machine may be damaged.
Check the tine conditioner for bent and damaged tines each time before it is used.
To prevent the loss of tines, check the bearing bolts of the tine bearings and replace them
in time.
