8
Operation
8.5
Lowering the machine from transport position to working position
54
EasyCut B 870 CV Collect
Original Operating Instructions 150000707_01_en
Lifting both mowers simultaneously from working position to headland position
Move toggle switch (3) to “
centre
” position.
Actuate the control unit (2+) until both mowers are raised into headland position.
Moving right mower from headland position to working position
Move toggle switch (3) to “
left
” position.
Actuate control unit (2-) until the right mower is lowered into working position.
To mow, move control unit (2-) to float position.
Moving right mower from working position to headland position
Move toggle switch (3) to “
left
” position.
Actuate the control unit (2+) until the right mower is raised into headland position.
Moving left mower from headland position to working position
Move toggle switch (3) to “
left
” position.
Actuate the control unit (1-) until the left mower is lowered into working position.
To mow, move control unit (1-) to float position.
Moving left mower from working position to headland position
Move toggle switch (3) to “
left
” position.
Actuate the control unit (1+) until the left mower is lifted into headland position.
Lifting/lowering cross conveyor belts
ü
The mowers are in headland position or working position.
Move toggle switch (2) to “
bottom
” position.
Lifting/lowering cross conveyor belt on right
Move toggle switch (3) to position “
right
”.
To lift:
Actuate the control unit (2+) until the right cross conveyor belt is raised.
To lower:
Actuate the control unit (2-) until the right cross conveyor belt is lowered.
Lifting/lowering cross conveyor belt on left
Move toggle switch (3) to “
right
” position.
To lift:
Actuate the control unit (1+) until the left cross conveyor belt is lifted.
To lower:
Actuate control unit (1-) until the left cross conveyor belt is lowered.
Increasing/reducing conveyor belt speed
Increasing:
To increase the speed, turn the rotary potentiometer (4) to the right.
Reducing:
To reduce the speed, turn the rotary potentiometer (4) to the left.
From headland position to transport position
ü
The PTO shaft drive is switched off.
