10
Settings
10.6
Checking/setting locking of side guards
64
EasyCut B 870 CV Collect
Original Operating Instructions 150000707_01_en
The protective equipment can be adapted to harvesting conditions by adjusting the guards. In
order to avoid that crop stalks bend because the guards are too low, set the guards higher. To
avoid that stones are slung away when the crops are low, set the guards lower.
ü
The machine is in the working position,
.
ü
The machine is shut down and safeguarded,
.
Adjusting the side guard (1)
Use a screwdriver (8) to press down the catch and fold up the side guard (1).
Loosen the screws (4).
Use the console (5) to adjust the height of the side guard (1).
Tighten the screws (4).
Adjusting the side guard (2)
Fold up the front guard (3),
.
Loosen the screws (6).
Use the console (7) to adjust the height of the side guard (2).
Tighten the screws (6).
Adjust the two side guards identically.
10.6
Checking/setting locking of side guards
KMG000-042
The locking (2) prevents during use that the side guard (1) is folded up and foreign bodies are
slung away. Therefore make sure every time before using the machine that the side guard (1) of
the machine is folded down and secured by the locking (2).
Check the lock
Move the machine to the working position,
ð
If the side guard folds down, it is correctly set.
ð
If the side guard does
not
fold down, the locking must be set.
Move the machine to the transport position.
ð
If the side guard folds down, the side guard is correctly adjusted.
ð
If the side guard does
not
fold down, the lock must be adjusted.
