10
Settings
10.10 Setting conveyor belt
68
EasyCut B 870 CV Collect
Original Operating Instructions 150000707_01_en
In case of wide spreading, adapt the widespreading sheet to the amount of forage.
Tighten the palm knobs (1) manually.
Ensure that the palm knobs are tightened as tight as possible. Otherwise they may be lost
due to vibrations.
10.10
Setting conveyor belt
KM000-061
The drive roller (1) and the idle roller (2) can be set on both sides.
Setting the tension of the conveyor belt on the idle roller (2)
ü
The machine is in the working position,
.
Raise the cross conveyor belts,
.
Shut down and safeguard the machine,
.
Loosen the nuts (3) at position (III) and (IV).
Loosen the counter nuts (5) of the clamping screws (4) at position (III) and (IV).
To relieve the conveyor belt, loosen the clamping screws (4) at position (III) and (IV).