Settings
10
Adjusting the relief spring(s)
10.4
EasyCut B 970
Original Operating Instructions 150000711_01_en
61
The overcut to the front mounted mower can be reduced/increased on right and left machine
side via the outrigger arms (2).
Position I
max. mowing width
Position II
Increase overcut by 7.5 cm (on each side)
Position III
Increase overcut by 15 cm (on each side)
ü
The machine is connected to the tractor,
ü
The machine is in the transport position,
ü
The machine is shut down and safeguarded,
.
WARNING! Crushing hazard caused by the outrigger arm (2) slipping out. The locking pin
(1) must be engaged properly in one of the positions (I, II or III).
Pull the locking pin (1) and move it into position I, II or III. Perform the same setting on the
right and left sides of the machine.
Ensure that the locking pin (1) is engaged.
Ensure that the locking pin (1) is freely movable in the oblong hole (I, II or III).
10.4
Adjusting the relief spring(s)
WARNING
Risk of injury due to incorrectly set relief spring(s)
If the threaded rod of the relief spring is screwed out too far, the compensation spring may
tear off and the mower may lower unintentionally. People may be seriously injured or killed as
a result.
Never
unscrew the threaded spindles (2) of the relief springs (1) further than the
dimension X
= 80 mm.
WARNING
Risk of injury due to adjustment of relief spring(s)
In the working position the relief spring(s) are subject to high drawing tension. In case an
attempt is made to remove or adjust the relief spring(s) when the machine is in the working
position, people may be seriously injured or killed.
The relief spring(s) must only be dismounted or adjusted in the transport position.
The bottom fittings on the relief spring(s) are fully screwed in.
NOTICE
Machine damage due to incorrectly set relief spring(s)
If the dimension
a
is changed, the nuts (3) may come into contact with the rocker arm (4).
This may damage the machine. The dimension a is set in the factory to 3-5 mm.
Never change dimension
a
.
