Table of Contents
3
Pos : 4 /Ü berschrif ten/Ü bers chrift en 1/F-J/ Inhalts verzeic hnis @ 31\ mod_1251969952727_78.doc x @ 302165 @ 1 @ 1
1
Table of Contents
Pos : 5 / BA/I nhalts verz eichnis Spr ac henneutr al @ 10\ mod_1221574899104_0.doc x @ 135495 @ @ 1
1
Table of Contents ...................................................................................................................................3
2
Foreword .................................................................................................................................................6
3
Introduction.............................................................................................................................................7
3.1
Purpose of Use .................................................................................................................................. 7
3.2
Validity ............................................................................................................................................... 7
3.2.1
Contact........................................................................................................................................... 7
3.3
Identification Plate ............................................................................................................................. 8
3.4
Information Required for Questions and Orders................................................................................ 8
3.5
Intended Use ..................................................................................................................................... 9
3.6
Technical data ................................................................................................................................... 9
4
Safety .....................................................................................................................................................10
4.1
Identifying Symbols in the Operating Instructions ........................................................................... 10
4.2
Identification of the hazard warnings ............................................................................................... 10
4.2.1
Personnel Qualification and Training........................................................................................... 11
4.2.2
Dangers in Case of Non-compliance with the Safety Instructions............................................... 11
4.2.3
Safety-conscious work practices ................................................................................................. 11
4.3
Safety Instructions and Accident Prevention Regulations............................................................... 12
4.4
Attached devices ............................................................................................................................. 13
4.5
PTO operation ................................................................................................................................. 14
4.6
Hydraulic system ............................................................................................................................. 15
4.7
Maintenance .................................................................................................................................... 15
4.8
Unauthorised Conversion/Modification and Spare Parts Production .............................................. 16
4.9
Inadmissible Modes of Operation .................................................................................................... 16
4.10
Working in the vicinity of power transmission lines ......................................................................... 16
4.11
Introduction ...................................................................................................................................... 17
4.12
Position of the Adhesive Safety Stickers on the Machine ............................................................... 18
4.12.1
Re-Ordering the Adhesive Safety and Information Labels ...................................................... 20
4.12.2
Affixing the Adhesive Safety and Information Labels .............................................................. 20
5
Commissioning.....................................................................................................................................21
5.1
First installation ................................................................................................................................ 21
5.2
Special Safety Instructions .............................................................................................................. 21
5.3
Mounting onto the Tractor................................................................................................................ 22
5.3.1
Clutching points ........................................................................................................................... 22
5.4
PTO shaft......................................................................................................................................... 23
5.4.1
Length adjustment ....................................................................................................................... 23
6
Start-up ..................................................................................................................................................25
6.1
Mounting onto the Tractor................................................................................................................ 25
6.2
Hydraulics ........................................................................................................................................ 27
6.2.1
Special Safety Instructions .......................................................................................................... 27
6.2.2
Connecting the hydraulic lines..................................................................................................... 27
6.3
PTO shaft......................................................................................................................................... 29
6.4
Install the PTO shaft ........................................................................................................................ 30
6.5
Intermediate PTO shaft.................................................................................................................... 30
6.6
Swivelling parking support into transport position ........................................................................... 31
6.6.1
Four supports (optional)............................................................................................................... 31
Summary of Contents for EasyCut R 280
Page 85: ......
