Maintenance
62
Pos : 24.33. 30 / BA/ Wart ung/M ähwer ke/ St oß kant en erneuern @ 0\ mod_1197271320468_78.doc x @ 16636 @ @ 1
10.12
Replacing the linings
Caution! - If the linings are checked irregularly.
Effect: Damage to the machine
•
Always check the mowing unit for damaged linings prior to start-up and replace linings, if
necessary!
•
Adjust the welding current and the welding material to the cutter bar material and to the
lining or carry out a trial welding if necessary.•
EC-0-012
Fig. 37
•
Open the welding seams of the old lining.
•
Remove the lining
•
Deburr the contact surface.
EC-252-0
Fig. 38
•
Adapt the new lining (3).
•
Weld short I seams on the
upper surface
of the cutter bar in the areas marked (1) (each
should be approx. 30 mm).
•
Do not weld the edges (2).
•
On the
lower surface
of the cutter bar, weld the lining (3) to the cutter bar along the
whole length in area (5).
•
Do not weld the edges (4).
Pos : 24.34 / BA/---------------Seitenumbr uc h---------------- @ 0\ mod_1196175311226_0.doc x @ 4165 @ 3 @ 1
Summary of Contents for EasyCut R 280
Page 85: ......
