Instruction Manual KG-453
27
Working with the 3-tube feeder
Its purpose is to slice long and thin ma-
terial (e.g. cucumbers or carrots).
Before operating make sure that the col-
lecting container
(7)
and the ejector
(8)
are installed. Install the slicing disk and
close the lid
(3)
.
In addition, swing the 3-
tube feeder
(17)
to the right and move it
to its lower position.
You can choose from three different
opening sizes. The smallest opening is
for thin cuttings (e. g., carrots, leeks) and
the two larger openings are for thicker
cuttings (e. g., cucumber, zucchini).
Remove the pusher
(18)
out of the se-
lected slicing compartment and fill the
small compartment with material. Start
the engine by pushing the green button
(10)
and use the pusher
(18)
to push
the food with moderate force.
Advice: Insert the long material always with the peak first.
Never use anything else but the pusher (5) or other cut-
ting material for pushing down the material.
18
17
3
