The flanges on HEAT are designed to fit to the standard air tubes in
the caravan. Internally Ø65mm (65mm tube) or externally Ø67mm
(72mm tube). Two small holes in the flanges are used to secure the
tube by use of a small screw.
Connections:
The power cord is connected to the 230V supply in the wagon in a
proper way. Make sure that the connection can handle a power
consumption of 6,5 Amp.
HEAT is delivered with the power cord and the controller cord
connected into the heating device. Thus it is not necessary to open
HEAT before installation.
The control panel is placed where the temperature in the wagon are
normal.
The temperature regulation is done in the control panel. Inside the
control panel a temperature sensor is installed. Therefore it is
important that the control panel is placed in a way that it can sense
the temperature in the wagon and not have the risk of being covered
in any way.
HEAT is delivered with 5 meter wire for the control panel equipped
with a standard plug.
Any excess wire after the installation are coiled and strapped.
The back plate on the control panel is removed and is installed in the
wagon. It can be placed on a bulkhead or on a closet wall. Secure
this back plate with 4 small suitable screws. Drill a 13mm hole in the
plate the back plate is installed onto. The wire for the control panel
are guided to this hole and inserted into the hole. The plug on the
wire is inserted into the socket of the control panel and the control
panel is clicked onto the back plate.
The installation has now finished and is ready for action.
You might find inspiration for installation on our homepage at:
18
