© Termo-tehnika, d.o.o.
17-16-27-3033-00
12
07/2016
6.3 Transport
Before transport, the heat pump must be protected with protective foil or cardboard packaging
to avoid damage such as indentations and bruising. If needed, it can also be additionally
protected from mechanical damage. After placing the device into final position, the device must
stand still for a minimum of 2 hours before start-up in order for the oil to flow back into the
compressor.
The upper part of the device with the generator protected by a plastic lid does not bear larger
loads. This is why it
must not
be used as a bearing or supporting point during transport.
CAUTION
While moving the device, it has to be disconnected from the power supply.
WARNING
The mass of the device is too great for manual transfer. This could lead to
injuries and damage of the device. All responsibility for eventual injuries or
damage to property or the device is taken by the user.
Devices for transporting goods must be used.
CAUTION
The heat pump must under no circumstance be laid in horizontal position.
6.4 Installation location
The heat pump can be installed in rooms which can be cooled (DHW room, pantry, basement
...). It must not be installed in rooms where there are harmful substances in the air (stables,
warehouses with dangerous substances, the outdoors ...). The minimal room space is 20 m
3
.
The heat pump is designed to take the heat from the surrounding air or suck the air through
air channels and blow it into the adjoining rooms or surroundings.
Picture 2: Heat pump placement
