Krontek KT160 Rev 4.10
5
7 Setting the Date
Note: The calendar clock will automatically calculate and display the day of week (Mon-Sun) from
the date. The non-calendar clock requires the date to be set to enable daylight savings to
operate.
Press SYS six (6) times, the date will display as DDMMYY and DD will flash.
To change the day of month use ADJ.
Press SYS to select the month.
To change the month use ADJ.
Press SYS to select the year.
To change the year use ADJ.
Press SYS to set the year and advance to setting the alert message.
8 Setting the Action Message
Press SYS nine (9) times, the date will display as DDMMYY and DD will flash.
To set the action message you must step through the date setting with the SYS key.
The action message is activated when a 24vdc voltage is applied to the action terminals on the
rear of the clock.
There are three display options for the action display (2 for the non-calendar clock) these are:
1. Alert
2.
Evacuate (calendar clock only)
3.
Timer
Select the desired action message using the ADJ key.
If Alert or Evacuate is selected press TIME to exit to the normal display.
If timer mode is selected you have the option of a count up or count down timer.
If the timer display is set to 00:00:00 the timer will count up from zero to 23:59:59 then roll over to
zero and continue counting.
To preset the timer for count down mode, press the SYS key and the hours will flash, use the
ADJ key to change the setting then press SYS to proceed to minutes, then again for seconds.
SYS must be pressed after seconds to keep the selected time.
When action is activated the display will count down to 00:00:00 and remain there until action is
deactivated, the preset time is then reloaded.
Press TIME to exit back to the normal display.
