Remove protective cap from trolley post.
Place one safety stop on the trolley post.
Ensure the safety stop is fully seated and properly
aligned so this half of the post is completely covered
by the safety stop.
Slide the second safety stop over the other side of the
post.
Ensure that both safety stops are aligned and fully
seated.
Thread provided screws into both sides of the safety
stops using a #2 Phillips Screw Driver and lightly tighten.
Repeat above steps for second trolley.
NOTE: Please keep the protective cap and reuse when
removing and rehanging panel to prevent damage to
your track.
27.
I N STA L L SA F E T Y ST O P S
1
2
5
3
4
3
Not following the above instructions can
cause a hazardous condition. Installation
with both screws is mandatory.
If installing Premium Door Stops, reference those installation instructions in parallel.
S EC U R E F RO N T T R AC K T O R E A R T R AC K
26.
Confirm the track has been leveled, shimmed, and all
mounting points have been securely fastened.
Inspect each track spring to ensure they are not
interfering with the mounting hardware and evenly
spaced along the length of the track.
Install 1/2” socket onto a torque wrench and torque
the track bolts to 120 inch-lbs (10 ft-lbs).
Carefully reattach the track cover.
Confirm the track cover is fully seated and securely
attached along the length.
Ensure that the arrow on the inside of the track cover is
facing up.
Carefully hang your front panel.
1
2
3
4
5
6
3
