12.
I N STA L L E N D C A P S T O R E A R T R AC K
Use the provided fasteners and a 1/16” allen wrench to
gently secure the end cap to the rear track. Do not
over-tighten!
Repeat on the other end of the track, if applicable.
1
2
End cap assembly may vary at each end of the track.
Select the scenario below that best matches the track configuration:
• No perpendicular wall fittings – follow the steps below for each end.
• Perpendicular wall fitting on one end – follow the steps below for the opposite end.
• Perpendicular wall fittings on both ends – the track was completed in the previous step. Proceed to the next step in these instructions.
13.
M O U N T R E A R T R AC K T O WA L L
Slide springs to the ends of track, but keep 1” away
from holes to prevent clamping a spring under track
washer plate. Evenly space springs along the length of
track to ensure the cover is well-retained.
Ensuring that the black plastic track cap faces up,
loosely install one end of your track with the appropri-
ate track spacers and hardware.
Repeat with the opposite end of the track.
Support the track assembly along its length if multiple
tracks are linked together.
With both ends of the track now supported, loosely
install the remaining mounting points.
1
3
4
2
2
3
4
1”
See step 9
Optional
track stand-off
