Krueger | 1401 N Plano Rd | Richardson, TX 75081 | 972.680.9136 | kruegerinfo@krueger-hvac.com | www.krueger-hvac.com
KAH Operation & Maintenance Guide
Page: 4 of 88
GENERAL SAFETY GUIDELINES
This equipment is a relatively complicated apparatus. During installation, operation maintenance or service, individuals
may be exposed to certain components or conditions including, but not limited to: refrigerants, UV, materials under
pressure, rotating components, and both high and low voltage. Each of these items has the potential, if misused or
handled improperly, to cause bodily injury or death. It is the obligation and responsibility of operating/service personnel
to identify and recognize these inherent hazards, protect themselves, and proceed safely in completing their tasks.
Failure to comply with any of these requirements could result in serious damage to the equipment and the property in
which it is situated, as well as severe personal injury or death to themselves and people at the site.
This document is intended for use by owner-authorized operating/service personnel. It is expected that these individuals
possess independent training that will enable them to perform their assigned tasks properly and safely. It is essential
that, prior to performing any task on this equipment, this individual shall have read and understood this document
and any referenced materials. This individual shall also be familiar with and comply with all applicable governmental
standards and regulations pertaining to the task in question.
IMPORTANT!
READ BEFORE PROCEEDING!
SAFETY SYMBOLS
The following symbols are used in this document to alert the reader to specific situations:
NOTE -
Highlights additional information useful to the technician in completing the work being performed
properly.
CAUTION -
Identifies a hazard which could lead to damage to the machine, damage to other equipment and/or
environmental pollution if proper care is not taken or instructions and are not followed.
DANGER -
Indicates a possible hazardous situation which will result in death or serious injury if proper care is
not taken.
WARNING -
Indicates a potentially hazardous situation which will result in possible injuries or damage to
equipment if proper care is not taken.
WARNING -
External wiring, unless specified as an optional connection in the manufacturer’s product line, is
not to be connected inside the control cabinet. Devices such as relays, switches, transducers and controls and
any external wiring must not be installed inside the micro panel. All wiring must be in accordance with Krueger’
published specifications and must be performed only by a qualified electrician. Krueger will NOT be responsible
for damage/problems resulting from improper connections to the controls or application of improper control
signals. Failure to follow this warning will void the manufacturer’s warranty and cause serious damage to
property or personal injury.
