- 21 -
A
Cutting to specified dimensions
•
The cutting size can now be set with the
handle
F
.
•
Insert paper and move by means of the
stacking angle to the backgauge
H
and
side lay on the left
I
.
•
Move the pressing lever
D
to the left by a
slight swing (only 4315).
• Close the front safety guard
A.
•
Release the cut.
Cut according to markings
•
Adjust the backgauge with the crank
handle
F
to the back.
•
Insert paper and move by means of the
stacking angle to the backgauge
H
and
side lay on the left
I
.
•
Turn crank handle
F
to the right until the
marking on the paper to be cut is below the
cutting line indicator.
•
Move the pressing lever
D
to the left by a
slight swing (only 4315).
• Close the safety guard
A.
•
Release the cut.
Cutting activation
Warning!
•
The front safety guard must be opened
completely before every cut (A).
•
Run backgauge to the front for turning the
paper stack.
•
Do not interrupt the upward movement
of the blade by performing switching
procedures.
•
Close the front safety guard
A.
• Blade must always be at the top and be
covered by the clamp. Do not touch the
blade
- risk of injury!
(see security information
on page 30).
Operation
