26
Owner’s manual
EN
Handling the Remote Control
•
Remove the batteries if the remote control is not going to be used for an
extended period of time.
•
To avoid possible failure, read the following instructions and handle the
remote control properly.
•
Do not drop or cause impact to the remote control.
•
Do not spill water or any liquid on the remote control.
•
Do not place the remote control on a wet object.
•
Do not place the remote control under the direct sunlight or near sources of
excessive heat.
•
Do not use caustic cleaners (porcelain, stainless steel, toilet, or oven cleaner
etc.) on the remote, as it may suffer damage.
Note:
Remove the battery from remote control handset when it is not to be used for a
long period. Otherwise it can be damaged due to leakage of battery.
Installation of Batteries
1. Remove the insulating strip
from the battery. It is located
at the bottom back side of the
remote control.
2. Loosen the screw on the
battery compartment cover
with a screwdriver. Pull out
the battery compartment with
your fingernails.
3. Replace a new battery
(size 2025) correctly and
fully insert the battery
compartment back to the
original position. Tighten the
screw with a screwdriver.
