Owner’s manual
Owner’s manual
EN
EN
24
25
Note: Make sure that you have set the time correctly.
1. In standby mode, press and hold TIMER button, until [TIMER SET] scrolls on
the display. The hour digits are displayed and begin to blink.
2.Press next / previous track button on the front panel or remote control to
set alarm mode and set hour, then press TIMER button again to confirm.
The minutes digits are displayed and begin to blink.
3.Press next / previous track button on the front panel or remote control to
set minute. Press TIMER button to confirm.
4.Press VOL +/– button to adjust volume, then press TIMER button to confirm.
5.In standby mode, press TIMER button repeatedly to activate / deactivate
timer The corresponding message TIMER ON or TIMER OFF will appear on
the screen.
SET ALARM TIMER
Press next / previous track button on the front panel ( or remote control) to
select a preset number
To switch between MONO and STEREO modes, press the REPEAT button on the
remote control.
To switch the currently displayed information, press the INFO button on the
remote control.
Tune to a preset radio station
Set the MONO and STEREO modes
Switching the currently displayed information
During play, press the VOL+/- button on the remote on use volume regulation
knob on the main unit to increase/decrease the volume level.
During play, press S-BASS button to turn on/off super bass enhancement. If
the function is on, the display will show BASS.
During play, press LOUDNESS button to turn on/off loudness function.
ADJUST VOLUME LEVEL AND SOUND EFFECT
Adjust volume level
Enhance bass
Loudness function
During play, press MUTE button to mute or restore sound
Mute sound
During play, press P-EQ button repeatedly to select:
FLAT / POP / JAZZ / ROCK / CLASSIC
Select a preset sound effect
After connecting USB devices (flash memory, memory card reader), the device
will play songs saved on the external data carrier. To do this:
1. Connect a USB device to the KM1961 USB port.
2.To select the USB function, use the mode dial on the main unit or the USB
button on the remote control. "USB" will appear on the display.
3.To start playback, press the play / pause button on the remote control or
the main unit.
4.To stop the track, press the play / pause button or the STOP button on the
remote control.
5.To change track, press the previous / next track button.
6.To rewind a track, press and hold the backward / forward button.
7. To change album, press the next / previous track button.
Charging external devices
When the device is connected to the power supply, the USB port on the front
panel can be used to charge external devices. The maximum charging voltage
is 5V
1 A.
PLAYBACK FROM USB
1. Use the mode dial on the main unit or the CD button on the remote to
select the CD function. "DISC" appears on the display.
2.Press the tray eject button on the remote or central unit, then place a disc
on it, and then press the tray eject button again.
3.To start playback, press the play / pause button on the remote control or
the main unit.
PLAYING FROM CDS
