Kruger KRK 160, Instruction Manual

ENGLISH

24

M1157-3_draft-0

•  Rotate the two legs T, which are located on the rear-bottom 

side of the frame, to make vertical the position of the dehu-

midifier.

•  Make sure the dehumidifier fits completely on the rear brack-

et M.

Safety locking

Install the safety bracket R in the bottom side of the dehumidi-

fier. The bracket must be fixed to the wall and the structure of the 

dehumidifier with the screws.

Pic.5 – 

The safety bracket

Do not operate the dehumidifier without the safety 

bracket. The safety bracket must be firmly screwed to 

the dehumidifier and the wall.

The absence of the safety bracket may cause an ac-

cidental fall of the machine and cause damage, even 

serious, to persons and property.

The exhaust pipe

For the drain connect a 14mm internal diameter rubber hose to 

the connection D on the lower-left side of the frame.

Pic.6 – 

The water drain

To ensure proper drainage of water make sure that 

the drain hose is sloped and well laid out, with no 

elbows or narrowing of any kind.

The control panel

Pic.7 – 

The control panel

S1 - Green light ON

 The green light indicates when the dehu-

midifier is operative, otherwise it blinks on status 0 (powered 

but off).

S2 - Red light, full tank 

The light blinks, together with the green 

one S1, when the tank is full, missing or incorrectly positioned.

S3 - Yellow light, defrost 

The light switches on during the auto-

matic defrosting cycle.

T1 - Decrease button

 Pushing this button will decrease the val-

ue of the display D down to 0.

T2 - Increase button

 Pushing this button will increase the value 

of the display D up to C.

D - Display

 The display shows the working state of the dehu-

midifier according to the table below (Tab.B). The value 0 means 

OFF, from 1 to 9 means automatic functioning and is controlled 

by the humidistat that switches the dehumidifier on or off if the 

value of the relative humidity is higher or lower than the one 

shown in Tab.B. The value C means ALWAYS ON and the dehu-

midifier works independently from the humidity value: never-

theless, any alarm has priority over the functioning mode.

Display

Functioning

0

Off

1 ÷ 2

from about 85% to 90% R.H.

3 ÷ 4

from about 70% to 80% U.R.

5 ÷ 6

from about 60% to 65% R.H.

7 ÷ 8

from about 45% to 55% R.H.

9

about to 40% R.H.

C

Continuous

Tab.B – 

Functioning modes

Failures

The display is used by the electronic device to show particular 

situations (Tab.C) If an error message is displayed please contact 

your dealer for repair.

Display

Description

n

Temperature probe must be checked

u

Humidity probe must be checked

Tab.C – 

Error messages