107
ENGLISHENGLISH
107
HOW TO DISASSEMBLE AND REASSEMBLE THE LID
HOW TO DISASSEMBLE THE METAL LID:
Grip the lid sub-assembly holding it by
the seal, and unscrew the central nut in an
anticlockwise direction. Remove the nut
then the lid.
PUTTING THE METAL LID SUB-
ASSEMBLY BACK IN TO PLACE:
Grip the lid sub-assembly by the seal as
shown in the picture. Line up the lid with
the central axis and press it flat against the
sub-assembly. Put the nut back on and
turn it clockwise, tightening it as far as it
will go.
HOW TO TAKE THE VALVE COVER OFF:
Clasp the valve cover by its middle part
(as shown); then turn it slightly to unclip
it. Clean the valve cover, paying special
attention to the inside (check that there is
no left over food).
PUTTING THE VALVE COVER BACK:
Take the valve cover as shown in the
picture (gripping the middle). Line up the
interior circular shape with the three hooks
and then push so that the valve cover clips
on (you should hear a “clip” sound). The
valve cover must be right up against the
inside of the lid.
ACCESSING THE DECOMPRESSION BALL:
Turn the ball cover, anti-clockwise, so as to bring the
I
marker into position . Lift the cover
up. Remove the ball, and gently clean it, along with its seat, with water and some washing-
up liquid. Dry the ball using a soft cloth, then put it back in position. Put the ball cover back
in place, and the marker
I
in position . Lock it by turning the ball cover so that the marker
is opposite the pictogram “closed” .
1
4
5
2
3
