Krups EA815 Manual Download

Page: 28 / 142

Rinsing the circuits :

Press the maintenance and settings button

(27). The function indicator

is shown above the mainte-

nance button

If necessary, using the navigation button,

select the rinse symbol

Press START

, rinsing starts and finishes when the coffee menu appears.

Automatic rinsing of the circuits when the machine starts.

■

You can choose to program the machine to be rinsed automatically each time it is turned on. To do this,
press the maintenance and settings button

(27). Using the navigation button

, select the automatic

rinsing programming symbol

. Press the

button to choose ON which confirms this program. If you

press the

, button, automatic rinsing is disabled.

■

You can return to the coffee types menu by pressing the

button.

Warning :

after this rinsing process, hot water will be released from the coffee jet. Ensure that the drip tray

is in place even when the machine is not being used. The cycle lasts only a few seconds and stops automa-
tically.

Cleaning program - total duration: approximately 13 minutes

You do not have to run the cleaning program as soon as the appliance requests it, but it must be done rea-
sonably soon after. If cleaning is postponed, the alert message will remain illuminated until the process is car-
ried out.

■

When the

symbol lights up, you can run the automatic cleaning program by pressing the maintenance

and settings button

. The

symbol is selected. The function indicator

is shown above the

maintenance button

■

the automatic cleaning program is divided into 2 stages: the cleaning cycle itself, followed by the rinse cycle.
You can clean the machine at any time by pressing the maintenance and settings button

then, using the

navigation button

select the cleaning symbol

■

To run this cleaning program, you will need a container which holds at least 0.6 L and which can be placed
beneath the coffee jets and the steam nozzle. The

symbol flashes.

■

Lift the cup grid (28).

■

Insert the KRUPS cleaning tablet (29).

■

Fill the water container to its maximum level of 1.7 L (2).

■

Empty the coffee grounds collector and the drip tray and clean the coffee drawer

(1)

(23-24-25).

■

Put a 0.6 L container under the coffee and steam jets (30).

■

Press START

. The

symbol becomes constant. The first phase (approximately 10 minutes) begins.

When this phase has finished, empty the container and the drip dray. The

symbol flashes. Put the parts

back in place.

■

Press START

. The

symbol becomes constant, the final phase (approximately 3 minutes) begins.

When this phase has finished, empty the container and the drip tray. The cycle has finished, the coffee
types menu appears.

Note:

if you turn off or unplug your machine during cleaning or if there is a power failure, the cleaning program

will start from the beginning of the program once the power is restored to the appliance. It is not possible to
postpone this process. It is obligatory in order to rinse the water circuit. In this case, a new cleaning tablet
may be necessary. It is best to run the full cleaning program in order to avoid any risk of poisoning. The
cleaning cycle is irregular: do not put your hands under the coffee jets while the cycle is running.

Descaling program - duration: approximately 20 minutes

You do not have to run the descaling program as soon as the appliance requests it, but it must be done rea-
sonably soon after. If descaling is postponed, the alert message will remain illuminated until the process is
carried out.
The amount of limescale collected depends on the hardness of your water.

Warning :

if your product is fitted with our Claris - Aqua Filter System cartridge, remove the cartridge before

descaling.

KR_ESPRESSO_EA815-16_8080014573_EO-EE_Mise en page 1 19/11/15 16:54 Page26