Krups Slice/IT 213 A, Instruction Book/Warranty

 Blade   extremely sharp.

Keep hands and fingers
away from the cutting edge

of the blade at all times.

l 

Operate the safety push

button with the thumb of

your right hand only.

 Operate slicer only if

blade, face plate, slicing

table, and food slide are

 assembled.

 Make sure that fingers of

your left hand stay away
fromthecuttingedgeof

the blade.

 Keep slicer away from

children.

cer for cutting frozen food.

Preparing the food slicer
(pictures   through 

Assemble the appliance as

shown in the main picture.
Unwind enough cord from

the cord storage compart-

ment underneath so that

the slicer can be plugged in
conveniently after it is set

up. Make sure that the cord
is guided properly through

the small opening slot on
the base of the slicer as

shown in the main picture.
Make sure that the slicer

sits on a flat and even sur-
face.

Unfold the slicing table as

shown in figure 

Unfold the food slide and
push down the vertical part

so that it engages firmly

(see figure 

 (for storage

purposes only: first pull up

the vertical part, then fold

down).
Engage the food slide with

the sliding table as shown

in figure   and lower the

food slide onto the slicing
table. Make sure that the
tongue of the food slide

inserts properly into the

grove between the slicer
and the sliding table.

Place a plate on the other

side of the food slicer (see

figure 

 to catch the cut

food.

Setting the Cutting
Thickness (see figure 

Select the desired cutting
thickness by turning the
slice thickness selector
wheel.The numbers (from 1
to 8) on the top of the face

plate indicate the actual

setting and serve as

memory. Each number cor-
responds to approximately

2 mm 

 of an inch).

When you have finished
slicing always turn the
thickness selector wheel
anti-clockwise so that the

dots to the right of the set-

ting 1 are clearly 
way the face blade extends

over the cutting blade. If you

turn the slice thickness
selector further anti-clock-
wise the face plate can

come out.

S i i i

Plug in appliance and place

food on the food slide (see

fig. 

 press the starter

button and keep depressed.

Then push the safety push

I

button 

 both but-

tons have been pressed one
after the other the food 

cerwill start (see figure 

You can now releasethe
safety starter button.With
the other hand you guide
the food slide. Keep the
safety push button de-

pressed with the thumb of

your right hand as long as

you want to slice. Gently

press the food against the

face plate while slicing.

When you release the
safety push button, the food
slicer will stop.To restart
see the above instructions.

Slicing small pieces and

leftovers

Unfold the end piece holder
(see figure 

 and attach it

to the food slicer as shown

in figure   Make sure that

the piece holder is engaged

properly to the food slide.
Use your left hand to guide

the end piece holder and

the food slide, while the

thumb of the right hand

holds the safety push but-

ton down.