code R30020.100en www.kseniasecurity.com
ed.04/2020
In case the keys of the same opera remote command are associated to different auxi wls, by pressing a key
the relay outputs react as follows:
OUTPUT MANAGEMENT THROUGH PANEL SCENARIOS
In case auxi wls is associated to a lares 4.0 control panel, the activation / deactivation of the outputs can be
managed also through the panel. In the same way as the panel outputs, the outputs on auxi wls can
commute when a particular event occurs, or can be manually activated through web server.
QUANTITY DATA
LED FUNCTIONS
Powering it up, the LED on device quickly blinks 3 times. Once stops blinking, if there are programmed opera
remote commands and the device is working in stand-alone mode, the led stays steady on. If the device
works as a wireless peripheral of the panel, the led turns OFF. Once the starting phase is over, the led
indicates the reception of a valid radio command.
0 1 2
keys
In case the outputs are programmed as
independents, a short press of the key manages
the first output and a long press manages the
second output. In case the output are
programmed as SPTD (change over switch),
there is no difference between the short or the
long press of the key, considering that the
outputs commute together.
In case the outputs are programmed as
interlocked, the outputs reaction depends on
the previous status of the relay outputs. The
activation sequence is: first output activation,
output deactivation, second output activation,
output deactivation, first output activation
again and so on. The LED on opera remote
command, corresponding to the pressed key,
turns ON to confirm the operation
(left led > key 0, right led > key 2).
i key
not used
lares 4.0 models
wls 96
16
40
40 wls
140 wls
644 wls
Maximum number of
auxi wls I/O
8
8
20
20
64
64