EN
13
Relay switching time can be set to 1 or 5 seconds. In order to change it, follow the next steps:
1.
Enter the 6 digit Installer-PIN on the keypad and confirm with OK. The Installer-PIN can be found
inside the envelope included in the package.
2.
After two acending tones, the blue backlighting and red led switch on, yellow led starts blinking.
That indicates programming mode is active.
3.
Enter the 6 digit Installer-PIN again.
4.
A long high-pitched beep indicates that relay programming mode is active. the Blue backlighting
is on, the yellow and red leds blink.
5.
Enter the code “ 000000 ” for 1 second relay switching time or “ 010000 ” for 5 seconds
relay switching time. The numerical code has to be entered within the next 20 seconds.
6.
Press OK to confirm.
7.
If new time has been succesfully saved two ascendent tones are played and green led turns on.
8.
The programming mode is automatically closed.
NOTE:
the default relay switching time is 1 second.
OPENING PROCEDURE WITH MOBILE PHONE
To open the door with a mobile phone the following requirements must be satisfied:
1.
Mobile phone must be authorized
2.
Bluetooth
must be enabled on your mobile phone
Falling below the detection range,
ergo
A
recognize the mobile phone and the green led on the keypad starts blinking. At this point you only
have to press OK button.
OPENING PROCEDURE WITH CODE
To open the door with code, you only have to enter your code and confirm by pushing OK button.
NOTE:
if a single high-pitched beep sounds and the red led turns on, a wrong code has been entered.
OPERATION MODE
RESET AND FACTORY DEFAULT
To reset ergo A to factory default follow the next steps:
1.
Enter the 6 digit Installer-PIN on the keypad and confirm with OK. The Installer-PIN
can be found inside the envelope included in the package.
2.
After two acending tones, blue backlighting and red led switch on, yellow led starts blinking.
That indicates programming mode is active.
3.
Enter the 6 digit Installer-PIN again.
4.
A long high-pitched beep indicates that relay programming mode is active. Blue backlighting is
on,
yellow and red leds blink.
5.
Enter the 6 digit Installer-PIN for the third time.
6.
Factory default is performed and
ergo
A
restarts.
CHANGING THE RELAY SWITCHING TIME
Summary of Contents for ergo A KSI2100030.301 WHITE
Page 2: ......
