code R30021.110en www.kseniasecurity.com
ed.10/2020
INSTALLATION
ergo S (ergo M) keypads can be installed on any plain surface. Furthermore, on the back there are 3 easy-
open holes, suitable for DIN503 and for 60mm-screw-distance boxes.
STEP 1. OPENING
To open the keypad, please proceed as follows:
1. Push snap fingers (A) using a screw driver
2. Pull outward
STEP 2. WALL MOUNTING
1. Push the cable through to the opening (7)
2. Fix the keypad base to the wall-box with the supplied screws through the eyelets (1) and (3).
3. Drill and install a screw with a wall plug to perform the tamper function (4).
For wall mounting the keypad, use suitable wall plug (not supplied) through the hols (1-3 or 1-2).
Legend
1.-3. Easy open hole to be opened to Built-In
installation on DIN 530 box
1. -2. Eyelets for 60mm-screws-distance boxes
4. Place a wall mount screw to enable anti
opening and removal tamper (4)
5. Remove the part and used to close the side hole
(8). The hole is reserved for future use.
6. Speaker
7. Cable gland
8. Side hole (for future use)
