code R30045.110en www.kseniasecurity.com
ed.06/2022
RGB LED multicolor
The led, if personalized, takes the same color as the arming status of the system. The colors associated with
the preconfigured scenarios are:
• red = total armed
• blue = partial armed
• green = disarmed
The led lighting timer can be configured (P.V.: 0 = always ON, timer from 1 to 240 seconds).
Important note
When the “Display zones status” option of ergo-X is enabled:
1. the yellow flashing led indicates that a memory alarm is present in case the system is disarmed or
there is an alarm in progress/restored in case the system is armed. The flashing yellow alternates with
the with the color of the arming state. For example:
- green/yellow = system disarmed/alarm memory;
- red/yellow = system armed/alarm in progress or restored.
2. the led OFF indicates that the system cannot be armed due to some zones in alarm. Led can turn ON
when you exclude those zones.
RFID Area
The keypad has an antenna on board with which recognizes the user's key/mini-Tag and that allows the
installer to enroll the key/mini-Tag.
Keys 0...9
The numeric keys (from 0 to 9) are used to enter the PIN code and to run the scenario associated with the
configuration. It is possible to configure each key "With PIN", so that the user must enter the code before
pressing the key that runs the scenario, or "Without PIN", in this case the user does not have to enter the
code but simply hold down for 3 seconds the key that runs the scenario.
The keys light up automatically the moment your hand approach to enter the code and at the end the light
will turn off. Just in case a sabotage occurs, the keys remain lit.
Key X
While entering the PIN code, it is possible to cancel the wrong digits by pressing <X> key.
Buzzer
Feedback sound on operations can be enable/disabled.
