EN
6
WIRING AND PROGRAMMING
RED
LABEL
N.C.
TAMPER
TERMINALS
(ON THE TOP SIDE)
1° L.E.D. ON = OPTICAL SYNC
Tx
JP2
LED 1
LED 2
WHITE
LABEL
N.C.
ALARM
GND (0 Volt)
+ 12 Vcc
N.C.
TAMPER
GND (0 Volt)
+ 12 Vcc
2° L.E.D. ON = ALARM
OPERATION
PRESET MODE on the Receiver
Mode 1
(
LED 1-SYNC
FLASHING):
Direct rays
– Alarm with
one Ray
– T – int
240
mSec
Mode 2
(
LED 2-ALARM
FLASHING):
Direct rays
– Alarm with
two Rays
– T – int
120
mSec
Mode 3
(
LEDs 1+2
FLASHINGS):
Crossed Rays
– Alarm with
two Rays
– T – int
120
mSec
BARRIER RECEIVER Programming
1)
Make a
SHORT-CIRCUIT with a screwdriver for 5 seconds JP2
2)
The LEDs
FLASHING
in the
Set MODE
3)
MODES
1, 2, 3
are selected by opening and
SHORT-CIRCUITING
4)
Open 5
seconds to
exit PROGRAMMING
