EN
58
INTRODUCTION
Depending on the programming of the system It can be operated via the keypad on the panel, the
wireless keypad or the wireless remote control.
The following section shows how to manage the system by this keypad on the panel. Instead, to
manage by remote control or wireless keypad, refer to the corresponding manuals.
SYSTEM MANAGEMENT BY KEYPAD
INFORMATION IN REST CONDITION
During normal operation of the system, on the keypad display it is possible to view a series of system-
related information.
The first line shows the overall status of the system. In order of priority, information displayed are:
MAINTENANCE
maintenance in progress by the installer. In this mode, the
control panel does not process alarms or sabotage.
PANEL BLOCKED
the actions block mode of the control panel is enabled.
In this state the control panel doesn't make any action in
case of alarms and sabotage.
TAMPER
tamper in progress
ALARM!
alarm in progress
MEM. SABOTAGE
a sabotage message on the system memory
ALARM MEMORY
an alarm message on the system memory
FAULT CONDITION
least one faulty in the system
ENTRY DELAY
entry time
EXIT DELAY
exit time
BYPASSED SENSOR
is at least one manually excluded sensor
during the insertion phase or in the main menu. The
excluded sensors are not notified on the keyboard display
SYSTEM OK
none anomalies
The second line of the display shows the following information:
• Date and time
• Arming state of the system
• System ready (all sensors are inactive and there are no other causes that prevent any input) or not
ready (one or more arming modes are prevented due to sensors violated or other causes)
• Outdoor temperature (if in the system is present also a Imago wls siren)
• Indoor temperature or Programmable thermostat (if enabled)
NOTE: The outside temperature may not be accurate in minutes just after a power-up and in the event
of a prolonged activation of the siren.
OPERATIONS IN REST CONDITIONS
The following operations can be carried out from the rest state:
• By pressing the ENTER key you can view the cause of any alarm status, alarm memory, tamper, tamper
memory or failure notified by the keyboard.
• By pressing the # key you can view the status of partitions.
• By pressing the * key, you can view the status of the sensors
• Turn on one of six programmable scenarios pressing one of the number keys 1 to 6 for 3 seconds
• PIN Entry
