Ÿ
Safety of users depend upon the continued efficiency and durability of the equipment.
Ÿ
This is advised that Annual Inspection should be done by competent person strictly in accordance with manufacturers periodic
examination procedure & if found any discrepancy in product, service will be done at authorized service center only.
Ÿ
A full body harness is the only acceptable body holding device that can be used in a fall arrest system.
Ÿ
Store in cool dry place, preferably away from moisture, direct sunlight, extra acidic or basic conditions & sharp edges.
Ÿ
The component of complete system shall not be substituted.
0
0
Ÿ
For intensive cleaning wash in water at a temperature between 25 C to 50 C using a neutral detergent. It should be allowed to dry by
itself and be kept away from open fire or any other source of heat.
6.
INSTRUCTION FOR MAINTENANCE :
Follow the maintenance instructions procedure laid below strictly.
Ÿ
In case of minor soiling, wipe the equipment with cotton cloth or soft brush. Do not use any abrasive material.
LABELS:
( )
ii
( )
ix
( )
ix
(viii)
( )
iii
( )
v
( ii)
v
( )
vi
(v) UID for traceability
(ii) Identification & address of manufacturer's
(vii) Month/Year of Manufacture
The Sealed Retractable Fall Arrester Block is marked
with:
(viii) Norm & Year
(I) The CE mark showing that the product meets the
requirements of the PPE Regulation (EU)2016/425
MARKING EXPLANATION:
(iii) Type or product code
(iv) Wire/ Rope Length
(vi) Atex Certification
(ix) Read the instruction before use
(x) Complies with IP68 level as per IEC 60529
03
(I)
( )
iv
140kg Max
