SN
N
ST
T
It may not work properly if being left at
a temperature above or below the
Stand your appliance in a dry place to
For sufficient leveling and air
circulating in the lower rear section of
the appliance, the bottom feet may
need to be adjusted. You can adjust
them manually by hand or by using a
To allow the doors to self-close, tilt
Keep the appliance out of direct
sunlight rain or frost. Stand the
appliance away from heat sources
ƽ
ƽ
ƽ
ƽ
The side at which the door opens can
be changed, from the right side (as
supplied) to the left side, if the
Note: Before you start lay the
refrigerator
gain access to the base
you should
rest it on soft foam packaging or
similar material to avoid damaging
the backboard of the refrigerator
To
reverse the door
the following steps
1. Stand
the
refrigerator
upright
Open the upper door to take out all
door racks (to avoid rack sdamaged)
on its back in order to
,
.
,
.
.
.
İ
10mm
9
2. Stand the refrigerator upright, first
remove the screw cover
and loose
the screw
and unscrew
the upper
hinge cover
which is at the top right
corner of the refrigerator, and use a
putty knife or thin-blade
screwdriver
to prize the screw hole cover
which
is at the top left corner of the
refrigerator.
ķ
ĸ
Ĺ
ĺ
Warning! When reversing the door, the
appliance must not be connected to
the mains. Ensure that the plug is
8mm wrench
Model
A
B
1301
960
1172
938
C
740
670
HS-SK321
HS-SK251
