11g Wireless Security Router User Guide
- 52 -
read-only information about this router or have the authority
to change the configuration. Also, the administrator can define
any specific community and configure its limits as Read-Only
or Read-Write from the right side drop-down box.
WAN MAC Change:
The WAN MAC address can be changed from the original
values if necessary. Some ISPs require users to change the
WAN MAC address to a registered one when users change
their access equipment.
External Admin.:
Check
“Enable”
to allow you to configure the Wireless
Security Router from the WAN side. To access the setting
page from the external side, enter “
http://<WAN IP
Address>:8080”
into the web browser address bar and press
the “
Enter”
key.
MTU:
Check
Enable
if you want to set a maximum limitation for
incoming and outgoing packet size. Enter the maximum
packet size you wish to set in the
“Size”
column.
Block WAN Request:
To prevent
hacker intruding your network, check the
Enable
option to enable this function to reject all the unauthorized
requests from WAN side.
IPSec Pass Through:
Check the
Enable
to allow the IPSec packets to pass through
the Wireless Security Router if there is LAN PC using IPSec
for data communication with other Internet device.
PPTP Pass Through:
Check the
Enable
to allow the PPTP packets to pass through
the Wireless Security Router if there is LAN PC using PPTP
for data communication with other Internet device.
PPPoE Pass Through:
Check the
Enable
to allow the PPPoE packets to pass through
the Wireless Security Router if there is LAN PC using PPPoE
for data communication with other Internet device.
Remote Upgrade :
Check
Enable
if you want to allow the authorized remote
users to upgrade firmware from WAN side.
Reset Device:
Select
“Yes”
if you want to clear a connection, reboot, and
re-initialize the unit without affecting any of your
configuration setting.
Factory Defaults:
Select
“Yes”
if you want to return all the router’s current
settings to their factory defaults. Note that do not restore the
factory defaults unless it is absolutely necessary.
Apply
Click this
button after making any changes for activating the
settings.
Cancel
Click this button if you are not satisfied with the settings in
this page before clicking Apply.