0
0
4
4
0
0
5
5
0
0
2
2
0
0
3
3
0
0
9
9
0
0
bk
bk
0
0
6
6
0
0
bl
bl
0
0
1
1
0
0
7
7
0
0
8
8
0
0
bm
bm
30/ENGINE - WORK ON INDIVIDUAL PARTS
119
–
Check inner clutch hub
for damage and wear.
» If there is damage or wear:
–
Change the inner clutch hub.
–
Check pressure piece
for damage and wear.
» If there is damage or wear:
–
Change the pressure piece.
–
Check axial bearing
for damage and wear.
» If there is damage or wear:
–
Change the axial bearing.
–
Check the contact surface of pressure cap
for damage and wear.
» If there is damage or wear:
–
Change the pressure cap.
–
Check the length of clutch springs
.
Clutch spring - length
41.50… 43.00
mm (1.6339… 1.6929
in)
» If the clutch spring length is less than the specified value:
–
Change all clutch springs.
–
Place push rod
on a level surface and check for run-out.
» If there is run-out:
–
Change the push rod.
19.33
Disassembling the main shaft
600316-01
–
Clamp main shaft
in the vise with the toothed end of the coupling side facing downward.
Specification
Use soft jaws.
–
Remove stop disk
and fixed gear
of the second gear.
–
Remove the fourth-gear idler gear
and needle bearing
.
–
Remove stop disk
and lock ring
.
–
Remove the third-gear sliding gear
and lock ring
.
–
Remove stop disk
.
–
Remove the fifth-gear idler gear
and needle bearing
.
–
Take the main shaft out of the vise.
