0
0
3
3
0
0
4
4
0
0
5
5
0
0
6
6
0
0
7
7
0
0
1
1
2
2
30/ENGINE - WORK ON INDIVIDUAL PARTS
125
19.39
Checking/premounting the reverse gear shaft
600319-01
–
Check the pivot points of reverse gear shaft
for damage and wear.
» If there is damage or wear:
–
Change the reverse gear shaft.
–
Check that pin
is firmly seated in reverse gear shaft
.
» If the pin is loose:
–
Change the pin or the reverse gear shaft.
–
Check needle bearing
for damage and wear.
» If there is damage or wear:
–
Change the needle bearing.
–
Check the tooth faces and pivot point of reverse gear wheel
for damage and wear.
» If there is damage or wear:
–
Change the reverse gear wheel.
–
Check stop disk
and
for damage and wear.
» If there is damage or wear:
–
Change the stop disk.
600320-10
–
Mount stop disk
and the needle bearing.
–
Mount reverse gear wheel
with the smaller recess first. Mount stop disk
.
Info
After installation, stop disk
is flush with surface
.
Stop disk
is somewhat lower in the reverse gear wheel and is not flush.
–
Mount lock ring
.
