0
0
3
3
0
0
1
1
0
0
2
2
10/REAR WHEEL
63
100094-10
–
Loosen the screws
by four turns.
Alternative
1
–
Insert the tool
from the tool set into the hole
of the rear wheel eccentric
element.
Alternative
2
–
Use a special tool on the rear wheel eccentric.
Hook wrench (83019011000) (
–
To adjust the chain tension
, use the special tool to slowly turn at the rear wheel
to rotate the rear wheel eccentric element forward or backward.
Specification
Chain tension
140… 145
mm (5.51… 5.71
in)
Info
Rotating the rear wheel eccentric element forward increases chain tension.
Rotating the rear wheel eccentric element backward reduces chain tension.
The rear wheel eccentric element should always be positioned such that the
grease nipple
is visible. This ensures that the vehicle has the greatest
ground clearance.
–
Fully tighten screws
.
Specification
Screw, rear wheel eccentric element
M8
20
Nm
(14.8
lbf
ft)
–
Remove tool
.
14.7
Adjusting the toe width of rear axle
Warning
Danger of accidents
Changes to the chassis can strongly influence how the vehicle handles.
–
After making changes, always ride slowly to allow yourself to respond to vehicle handling.
–
Engage 1st gear.
100102-10
–
Loosen nuts
of the wheel hubs on both sides.
–
Jack up the vehicle. (
–
Remove the nuts
on both sides and take all parts off of the rear axle.
–
Check parts for damage and wear. Replace damaged or worn parts.
Info
The left and right toe width should have the same settings.
100103-10
Setting a narrow toe width:
–
Mount the wheel hub
.
–
Mount the conical ring
with the cone facing outward.
–
Mount the spacing sleeve
with the cone facing inward.
–
Mount the washer and the new self-locking nut.
