10/REAR WHEEL
65
600412-10
–
Take brake disc
off the rear axle with the holder.
–
Remove the O-ring.
600414-10
–
Push the rear axle slightly to the left. Using a plastic hammer, lightly strike against
the chain sprocket carrier
to release the chain sprocket carrier from the lock
rings. Remove lock rings
.
–
Pull the rear axle out of the swingarm in the direction of the arrow.
Info
Hold the rear sprocket carrier.
–
Remove rear sprocket carrier
with the O-ring.
14.9
Installing the rear axle
Warning
Danger of accidents
Reduced braking due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
600422-10
–
Slide on the rear axle from the left to the right all the way.
Info
The machined surfaces
must be to the right of bearing seat
.
600423-10
–
Position O-ring
. Attach chain sprocket carrier
with the nuts facing outward.
–
Carefully insert sealing area
on the chain sprocket carrier into the shaft seal ring
of the rear wheel eccentric by lightly turning and tilting the rear axle.
Info
Do not damage the sealing lip of the shaft seal ring.
600424-10
–
Position lock ring
with the high collar facing to the left. Slide the main shaft all
the way in in the direction of the arrow.
–
Check that the lock rings are seated properly.