WORK
6
3.4
Installing the front fender
600692-10
–
Ensure that the spacers are mounted in the fender.
–
Position the front fender. Mount and tighten screws
.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
Info
Make sure the holding lugs engage in the start number plate or headlight
mask.
3.5
Installing the start number plate
500101-11
–
Position the start number plate. Mount and tighten screw
with the spacer.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
Info
Take care with the contact of the holding lug at the fender.
–
Position the brake line and wiring harness. Put the clamp on, mount and tighten
screw
.
3.6
Opening filler cap
400199-10
–
Press release button
, turn filler cap counterclockwise and lift it upwards and
remove.
3.7
Closing filler cap
400199-11
–
Replace the filler cap and turn clockwise until the release button
locks in place.
Info
Route the fuel tank breather hose
without kinking.
3.8
Refueling
Danger
Fire hazard
Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
Fuel in the fuel tank expands when warm and can escape if the tank is overfilled. See the notes on refueling.
Warning
Danger of poisoning
Fuel is poisonous and a health hazard.
–
Avoid contact of the fuel with skin, eyes and clothing. Do not inhale fuel vapors. If fuel gets into your eyes, rinse imme-
diately with water and contact a doctor. Wash affected skin areas immediately with soap and water. If fuel is swallowed,
contact a doctor immediately. Change clothing that has come into contact with fuel.
