38/LUBRICATION SYSTEM
183
101419-10
–
Remove screws
4
. Remove the oil filter cover with the O-ring.
101420-10
–
Pull oil filter
5
out of the oil filter housing.
Circlip pliers reverse (51012011000) (
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.
101421-10
–
Lay the motorcycle on its side and fill the oil filter housing to about
⅓
full with
engine oil.
–
Fill the oil filter with engine oil and place it in the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
6
.
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
M6
10 Nm (7.4 lbf ft)
–
Stand the motorcycle upright.
101422-10
–
Remove the oil filler plug
7
with the O-ring from the clutch cover and fill up with
engine oil.
Engine oil
1.20 l (1.27 qt.)
Engine oil (SAE 10W/50) (
Alternative engine
oil for harsh oper-
ating conditions
and increased per-
formance
Engine oil
(SAE 10W/60)
(00062010035)
Info
Too little engine oil or poor-quality engine oil results in premature wear to
the engine.
–
Install and tighten the oil filler plug with O-ring.
Danger
Danger of poisoning
Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and check that it is oil-tight.
Follow-up work
(EXC
‑
F AUS, EXC-F SIX DAYS)
–
Install the engine guard. (
–
Check the engine oil level. (