SET
‑
UP
4
B00534-10
–
Position
FI
warning lamp with holder
. Mount and tighten the screw.
Guideline
Remaining screws, chassis
M6
10 Nm
(7.4 lbf ft)
–
Plug connector
into the wiring harness.
–
Mount cable holder
on the frame.
B00535-10
–
Route the clutch line with the clutch master cylinder toward the front between
the upper and lower triple clamps.
–
Position the fork legs and tighten the screws of the triple clamp.
Guideline
Screw, top triple clamp
M8
17 Nm
(12.5 lbf ft)
Screw, bottom triple clamp
M8
12 Nm
(8.9 lbf ft)
Info
The upper milled groove in the fork leg must be flush with the top edge
of the upper triple clamp.
Position bleeder screws
toward the front.
0
0
8
8
0
0
7
7
0
0
8
8
7
7
B00375-11
–
Remove screws
. Remove the handlebar clamp.
–
Remove screws
. Remove the handlebar support.
–
Place the handlebar support in the required position. Mount and tighten screws
.
Guideline
Screw, handlebar support
M10
40 Nm
(29.5 lbf ft)
Loctite
®
243™
Info
Position the left and right handlebar supports evenly.
101020-10
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten the screws.
Guideline
Screw, handlebar clamp
M8
20 Nm
(14.8 lbf ft)
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
101017-01
–
Position the controls on the right half of the handlebar.
Info
The routing of the cables can be seen in the figure.
