WORK
7
3.4
Removing the seat
B00317-10
–
Remove screw
.
–
Lift up the seat at the rear, pull it back and then remove it from above.
3.5
Mounting the seat
B00318-01
–
Hook in the front of the seat at the collar bushing of the fuel tank, lower it at the
rear and simultaneously it push forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screw of the seat fixing.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
3.6
Installing the battery
B00361-11
–
Place the battery in the battery holder.
Battery (YTX4L-BS)
–
Reconnect rubber band
.
–
Attach the positive cable and replace the positive terminal cover
.
–
Attach negative cable
.
–
Mount the seat. (
3.7
Charging the battery
Warning
Risk of injury
Battery acid and battery gases cause serious cauterization.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well ventilated rooms.
–
Flush with copious amounts of water in case of skin contact. If battery acid comes into contact with the eyes, flush the
eyes with water for at least 15 minutes and consult a physician.
Warning
Environmental hazard
Battery parts and acid are harmful to the environment.
–
Do not discard batteries with the household trash. Dispose of a defective battery in an environmentally compatible manner.
Give the battery to your KTM dealer or to a recycling center that accepts used batteries.
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
