Concerning the driving feeling, there is no difference whether the drive system is operated
with the support switched OFF or on level 0. When the drive system with the LCD control
panel is switched ON, all the speedometer functions are available. The drive system works
most effectively at a cadence of 60 revolutions per minute. We recommend selecting the
drive level at all times according to actual needs, since the effectiveness of the drive system
increases with the correct choice of the support level.
Operation of the drive system
1
POWER button to turn the system ON and OFF
2
Indication of charging status of the batteries
3
MODE button for setting the support level
4
Indication of the level of support
5
LIGHT button to turn OFF the backlight
6
Assist UP button to increase the level of support
7
Assist DOWN button to decrease the level of support
8
Indicator light ON or OFF
9
Indication of the current consumed energy
10
Indication of the current speed
11
Speedometer function indication value (current value for the displayed speedometer
function)
12
Speedometer function indication: TOTAL KM … odometer / TRIP KM... Trip km /
O KM/H … Average speed / MAX-KM/H … /
Maximum speed
Turning the drive system ON and OFF
LED control panel + LCD control panel:
Press the POWER button to turn the drive system ON. At the beginning, all LEDs light red;
after two seconds, the current battery charging level and the support mode set will be
indicated by the red LEDs. To turn OFF, press the POWER button again.
LED control panel
LCD control panel
Example of display
during operation
Page 12
Calibration of the drive system when turning ON
ATTENTION
Never turn the drive system ON and OFF with pressure exerted
on the pedals! This may result in functional failures!
To allow the drive system to react properly to your pedal pressure, this automatically
performs a calibration during the first two seconds after power ON. During this process, the
torque applied on the pedal bearing is determined and it is reset to the zero starting value.
If you now place pressure on the pedal during power up, the drive
system measures the wrong value and, it can then subsequently
react improperly – an error is indicated. This will be indicated in the
Pedelec with LED control panel by alternating flashing of all LEDs of
the support levels and of all LEDs of the battery charging level; in
the Pedelec with LCD control panel, by the E1 error signal.
In this case, you should turn the drive system OFF once more and ON again with the
POWER button, without exerting pressure on the pedals –in this way, the error should be
corrected.
Adjusting the levels of support
LED control panel:
By pressing the Assist button UP or DOWN, the support level can be adjusted. There are
three different levels of strength of support available: ECO / STANDARD / HIGH. When
you turn the drive system ON, the support level is pre-set to STANDARD.
LCD control panel:
By pressing the Assist button UP or DOWN, the support level can be adjusted. There are
three different levels of strength of support available: ECO / STANDARD / HIGH. When NO
ASSIST is indicated, the system provides no support.
When you turn the drive system ON, the support level is pre-set to STANDARD.
Operation of the speedometer functions
For LCD control panel only:
The speedometer functions TOTAL KM … odometer/ TRIP-KM … Trip / O KM/H … Average
speed / MAX-KM/H … Maximum speed will be displayed under the speed readout on the LCD
display. To switch from one function to another, press the MODE button briefly; to reset the
trip odometer, travel time and average speed to zero, press the MODE key for longer than
three seconds.
Page 13
