BoWex-ELASTIC
®
Operating/Assembly instructions
Type HEW, HEW Compact and HEW-ZS
KTR-N
Sheet:
Edition:
40114 EN
11 of 24
9
Please observe protection
note ISO 16016.
Drawn:
2019-11-06 Pz
Replacing:
KTR-N dated 2019-08-13
Verified:
2019-11-06 Pz
Replaced by:
STOP
The maximum permissible bore diameters d (see chapter 1
- technical data) must not be exceeded. If these figures are
disregarded, the coupling may tear. Rotating particles may
cause danger to life.
•
Bores on the hubs/coupling flange machined by the
customer have to observe concentricity or axial runout
(see illustration 12).
•
Please make absolutely sure to observe the figures for
Ø d
max
.
•
Carefully align the hub or coupling flange when the finish
bores are drilled.
•
Please provide for a setscrew according to
DIN EN ISO 4029 with a cup point or an end plate to fasten
the hub or coupling flange axially.
Illustration 12: Concentricity and axial
run-out
!
The customer bears the sole responsibility for all machining processes performed
subsequently on unbored or pilot bored as well as finish machined coupling components
and spare parts. KTR does not assume any warranty claims resulting from insufficient
remachining.
KTR supplies unbored or pilot bored coupling components and spare parts only upon
explicit request of the customer. These parts are additionally marked with the symbol
.
Reference to unbored resp. pilot bored coupling components with explosion protection
marking:
Basically the company KTR supplies couplings resp. coupling hubs with explosion protection
marking as an unbored or pilot bored type only on explicit request of the customer. The prerequisite
is a declaration of exemption submitted by the customer assuming any responsibility and liability for
remachining performed properly.
Table 7: Setscrew DIN EN ISO 4029
Size
42
48
65
80
G 80
100
125
G 125
150
G150
200
G 200
Thread size
M8
M8
M10
M10
M10
M12
M16
M16
M16
M16
M20
M20
Tightening torque T
A
[Nm]
10
10
17
17
17
40
80
80
80
80
140
140
Table 8: Recommended fit pairs acc. to DIN 748-1
Bore [mm]
Shaft tolerance
Bore tolerance
above
up to
50
k6
H7
(KTR standard)
50
m6
If a feather keyway is intended to be used in the hub, it should correspond to the tolerance ISO JS9 (KTR
standard) with standard operating conditions or ISO P9 with complicated operating conditions (frequently
alternating torsional direction, shock loads, etc.).
The transmittable torque of the shaft-hub-connection must be reviewed by the customer and is subject to his
responsibility.
4
Assembly
4.2 Advice for finish bore