BoWex-ELASTIC
®
Operating/Assembly instructions
Type HEW, HEW Compact and HEW-ZS
KTR-N
Sheet:
Edition:
40114 EN
18 of 24
9
Please observe protection
note ISO 16016.
Drawn:
2019-11-06 Pz
Replacing:
KTR-N dated 2019-08-13
Verified:
2019-11-06 Pz
Replaced by:
Breakdowns
Causes
Hazard notes for
potentially explosive
atmospheres
Elimination
Excessive wear on the
spline of the elastomer
part, fracture of
elastomer
Vibrations of drive
Danger of ignition due to
hot surfaces
1) Set the unit out of operation
2) Disassemble the coupling and remove
remainders of the elastomer part
3) Inspect coupling components and replace
coupling components that are damaged
4) Insert elastomer part, assemble coupling
components
5) Inspect alignment, adjust if necessary
6) Find out the reason for vibrations
ambient/contact
temperatures which are
too high for the
elastomer part,
max. permissible
-30 °C/+80 °C
1) Set the unit out of operation
2) Disassemble the coupling and remove
remainders of the elastomer part
3) Inspect coupling components and replace
coupling components that are damaged
4) Insert elastomer part, assemble coupling
components
5) Inspect alignment, adjust if necessary
6) Inspect and adjust ambient/contact
temperature
e. g. contact with
aggressive liquids/oils,
influence by ozone, too
high ambient
temperature etc.
causing a physical
change of the elastomer
part
none
1) Set the unit out of operation
2) Disassemble the coupling and remove
remainders of the elastomer part
3) Inspect coupling components and replace
coupling components that are damaged
4) Insert elastomer part, assemble coupling
components
5) Inspect alignment, adjust if necessary
6) Make sure that other physical modifications of
the elastomer part are excluded
!
When operating with a worn elastomer part (see chapter 9.3 and 9.4) proper operation is not
ensured.
In respect of environmental protection we would ask you to dispose of the packaging or products on termination of
their service life in accordance with the legal regulations and standards that apply, respectively.
•
Metal
Any metal components have to be cleaned and disposed of by scrap metal.
•
Nylon materials
Nylon materials have to be collected and disposed of by a waste disposal company.
We recommend to store major spare parts on site to ensure the readiness for use of the machine in case if a
coupling fails.
Contact addresses of the KTR partners for spare parts and orders can be obtained from the KTR homepage at
www.ktr.com.
KTR does not assume any liability or warranty for the use of spare parts and accessories
which are not provided by KTR and for the damages which may incur as a result.
6
Breakdowns, causes and elimination
7
Disposal
8
Spares inventory, customer service addresses
