ROTEX
®
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
40210 EN
17 of 22
22
Please observe protection
note ISO 16016.
Drawn:
2017-09-06 Pz/Bru
Replacing:
KTR-N dated 2017-01-02
Verified:
2017-09-06 Pz
Replaced by:
In respect of environmental protection we would ask you to dispose of the packaging or products on termination of
their service life in accordance with the legal regulations and standards that apply, respectively.
Metal
Any metal components have to be cleaned and disposed of by scrap metal.
Nylon materials
Nylon materials have to be collected and disposed of by a waste disposal company.
ROTEX
®
is a low-maintenance coupling. We recommend to perform a visual inspection on the coupling
at least
once a year
. Please pay special attention to the condition of the spider of the coupling.
Since the flexible machine bearings of the driving and driven side settle during the course of load, please
inspect the alignment of the coupling and re-align the coupling, if necessary.
The coupling parts have to be inspected for damages.
The screw connections have to be inspected visually.
!
Having started up the coupling the tightening torques of the screws have to be inspected
during the usual inspection intervals.
With the use in hazardous locations please observe chapter 10.2
Inspection intervals for
couplings in
- hazardous locations
.
A basic requirement to ensure the operational readiness of the coupling is a stock of the most important spare
parts on site.
Contact addresses of the KTR partners for spare parts and orders can be obtained from the KTR homepage at
www.ktr.com.
KTR does not assume any liability or warranty for the use of spare parts and accessories
which are not provided by KTR and for the damages which may incur as a result.
7
Disposal
8
Maintenance and service
9
Spares inventory, customer service addresses
