KTR Kupplungstechnik
GmbH
D-48407 Rheine
B o W e x - E L A S T I C
®
Operating-/Assembly Instructions
Design 065 (HEW1 and HEW2)
KTR-N
sheet:
edition:
40114 E
12
4
Gezeichnet:
08.04.04 Sha/Hk
Ersatz für:
KTR-N vom 01.12.99
Schutzvermerk
ISO 16016 beachten.
Geprüft:
08.04.04 Sha
Ersetzt durch:
5 Enclosure A
Hints and instructions regarding the use in
hazardous areas
5.7 Breakdowns, Causes and Elimination
breakdowns causes
danger hints for
hazardous areas
elimination
drive vibrations
danger of ignition due
to hot surfaces
1) put the unit out of operation
2) disassemble the coupling and remove
rests of the elastomer part
3) check coupling parts and exchange
damaged coupling parts
4) insert elastomer part, assemble coupling
parts
5) check alignment, correct if necessary
6) find out the reason for the vibrations
ambient / contact
temperatures which
are too high for the
elastomer part, max.
permissible
-20 °C / +80 °C
danger of ignition due
to hot surfaces
1) put the unit out of operation
2) disassemble the coupling and remove
rests of the elastomer part
3) check coupling parts and exchange
damaged coupling parts
4) insert elastomer part, assemble coupling
parts
5) check alignment, correct if necessary
6) check and regulate ambient / contact
temperature
excessive wear at
the elastomer part
toothing
e. g. contact with
aggressive liquids /
oils, ozone-
influence, too high
ambient
temperatures etc.
effecting a physical
change of the
elastomer part
---
1) put the unit out of operation
2) disassemble the coupling and remove
rests of the elastomer part
3) check coupling parts and exchange
damaged coupling parts
4) insert elastomer part, assemble coupling
parts
5) check alignment, correct if necessary
6) make sure that further physical changes
of the elastomer part are excluded
A T T E N T I O N !
KTR does not assume any liabilities or guarantees regarding the use of spare parts and
accessories which are not provided by KTR and for the damages resulting here from.