KTR Kupplungstechnik
GmbH
D-48407 Rheine
POLY
Operating-/Assembly Instructions
KTR-N
sheet:
edition:
49610 EN
13 of 24
9
Gezeichnet: 11.03.10
Pz/Bru
Ersatz für:
KTR-N vom 25.04.07
Schutzvermerk
ISO 16016 beachten. Geprüft:
16.03.10 Pz
Ersetzt durch:
4 Assembly
4.5 Assembly of the Type PKA
•
Assemble the coupling flanges onto the shaft of the
drive and the driven side (see picture 16).
•
The inner side of the coupling flanges must end
flushly with the front sides of the shafts.
•
Move the power packs in axial direction until the
dimension L is achieved (see table 5).
•
Fasten the coupling flanges by tightening the
setscrews DIN EN ISO 4029 with cup point
(tightening torque see table 5).
picture 16: assembly of the coupling flanges
•
Please plug the driving flanges, spacer and the
elastomer elements together (see picture 17).
picture 17: assembly of the driving flange, spacer and
elastomer elements
•
Put the assembled parts between the coupling
flanges (see picture 18).
•
At first hand-screw the parts.
•
Tighten the screws with a suitable torque key to the
tightening torque T
A
shown in table 6.
•
Please check the L or the E dimension (see picture
18 and table 5).
picture 18: coupling assembly
!
C A U T I O N !
Having set the coupling into operation, the tightening torque of the screws and wear of
elastomer elements have to be inspected in usual maintenance intervals.
