25
OPERATING THE TRACTOR
B
Speed Set Device
The Speed Set Device is designed for tractor operating
efficiency and operator comfort. This device will provide
a constant forward operating speed by mechanically
holding the speed control pedal at a selected position.
C
To engage Speed Set Device
1. Accelerate speed to desired level using Speed Control
Pedal, and push the speed set lever down to the "ON"
position.
2. Release Speed Control Pedal and desired speed will
be maintained.
C
To disengage Speed Set Device
A
Pull the speed set lever upward.
A
Depress both brake pedals.
A
If you step on the pedal on the forward acceleration
side, the speed set device will disengage.
A
The speed set device does not disengage when the
individual right or left brake is applied.
A
Speed set device will not operate in reverse.
A
To prevent the damage of speed set device, do not
depress the reverse pedal when the speed set device
is engaged.
A
When you stand up from the seat with the speed
control pedal stepped on or the speed set device
engaged (ON), the engine will stop regardless of
whether the machine is moving or not. This is because
the tractor is equipped with Operator Presence Control
system (OPC).
STOPPING
B
Stopping
1. Slow the engine down.
2. Step on the clutch and brake pedal.
3. After the tractor has stopped, disengage the PTO,
lower the implement to the ground, shift the
transmission to neutral, release the clutch pedal, and
set the parking brake.
CHECK DURING DRIVING
B
Immediately Stop the Engine if:
A
The engine suddenly slows down or accelerates.
A
Unusual noises suddenly are heard.
A
Exhaust fumes suddenly become very dark.
B
Easy Checker (TM)
If the warning lamps of the Easy Checker(TM) come on
during operation, immediately stop the engine, and find
the cause as shown below.
Never operate the tractor while Easy Checker(TM) lamp
is on.
(1) Speed set lever
(2) Speed control pedal
(A) "ON"
(B) "OFF"
(C) "Increase"
(D) "Decrease"
(1) Easy checker(TM)
Engine oil pressure
If the oil pressure in the engine goes below the
prescribed level, the warning lamp in the Easy
Checker(TM) will come on.
If this should happen during operation, and it does
not go off when the engine is accelerated to more
than 1000 rpm, check level of engine oil.
(See "Checking Engine Oil Level" in "DAILY
CHECK" in "PERIODIC SERVICE" section.)
Summary of Contents for B2320
Page 1: ......
Page 14: ...SAFE OPERATION 6 7 DANGER WARNING AND CAUTION LABELS ...
Page 15: ...7 SAFE OPERATION ...
