1. Check front grill and side screens to be sure they
are clean of debris.
2. Detach the screen and remove all foreign materials
and clean the front of radiator completely.
(1) Recovery tank
(A) Detach
IMPORTANT :
• Grill and screen must be clean from debris
to prevent engine from overheating and to
allow good air intake for the air cleaner.
8. Checking brake pedals and clutch
pedal
1. Inspect the brake and clutch pedals for free travel,
and smooth operation.
2. Adjust if incorrect measurement is found.
(See Adjusting clutch pedal on page 73)
NOTE :
• Brake pedals should be equal when
depressed.
9. Checking the gauges, meter, and
Easy Checker
1. Inspect the instrument panel for the broken
gauge(s), meter(s), and Easy Checker.
2. Replace the instrument panel if broken.
10. Checking the head light, hazard
light, and so on
1. Inspect the lights for broken bulbs and lenses.
2. Replace the lights if broken.
11. Checking and cleaning of
electrical wiring and battery cables
WARNING
To avoid personal injury or death:
• A loosened terminal or connector, or damaged
wire may affect the performance of electrical
components or cause short circuits. Leakage of
electricity could result in a fire hazard, a dead
battery or damage to electrical components.
• Replace damaged wires or connections
promptly.
• If a fuse blows soon after replacement, do not
use a larger than recommended fuse or bypass
the fuse system.
• Many wiring connections are protected by
waterproof plugs, plug and unplug these
connections carefully and make sure they are
sealed correctly after assembly.
• Accumulation of dust, chaff and spilled fuel
deposits around the battery, electrical wiring,
engine or exhaust system may cause fire
hazards.
Clean these areas before starting work.
• To avoid premature electrical malfunctions, do
not apply high pressure water directly to
battery,
wiring,
connectors,
electrical
components or instrument panel.
Inspect the following regularly:
1. Check wiring for chafed or cracked insulation.
2. Check wiring harness clamps. Replace if necessary.
3. Check connectors and terminals for looseness,
contamination
or
overheated
(discolored)
connections.
4. Check instrument panel for correct operation of
switches and gauges.
Consult
your
KUBOTA
Dealer
regarding
maintenance, diagnosis and repair.
12. Checking seat belt and ROPS
1. Always check condition of seat belt and ROPS
attaching hardware before operating tractor.
2. Replace if damaged.
13. Checking movable parts
If any of the movable parts, such as levers and pedals,
is not smoothly moved because of rust or sticky
material.
Remove the rust or the sticky material, and apply oil or
grease on the relevant spot.
Do not force the movable parts in motion.
Otherwise, the machine may get damaged.
DAILY CHECK
PERIODIC SERVICE
B2401DT, B2401DTWO, B2401DTN
67
Summary of Contents for B2401DT
