ENGINE
GL6000A-AU-B, GL6000D-AU-B,GL9000A-AU-B, GL9000D-AU-B, WSM
1-S33
Gear Case
1. Remove the screw (1) of inside the gear case and outside
screws (6).
2. Disconnect the start spring (2) in the speed control plate
mounting hole.
3. Remove the gear case (3).
(When reassembling)
• Apply a liquid gasket (Three Bond 1215 or equivalent) to both
sides of the gear case gasket (4).
• Be sure to set three O-rings (5) inside the gear case.
9Y1211607ENS0047US0
Idle Gear
1. Remove the external snap ring (3), the idle gear collar (2) and
the idle gear (1).
(When reassembling)
• Install the idle gear, aligning the alignment mark (4) on the gears
referring to the figure.
9Y1211607ENS0048US0
Camshaft
1. Remove the camshaft mounting screws (1) and draw out the
camshaft (2) with gear on it.
(When reassembling)
• When install the camshaft, apply engine oil to the camshaft
journals.
• Apply engine oil to the camshaft mounting screws. And tighten
them.
9Y1211607ENS0049US0
(1) Screw (Inside)
(2) Start Spring
(3) Gear Case
(4) Gear Case Gasket
(5) O-ring
(6) Screw
Tightening torque
Idle gear shaft mounting
screw
9.81 to 11.2 N·m
1.00 to 1.15 kgf·m
7.24 to 8.31 lbf·ft
(1) Idle Gear
(2) Idle Gear Collar
(3) External Snap Ring
(4) Alignment Mark
(1) Camshaft Mounting Screw
(2) Camshaft
KiSC issued 06, 2016 A