PERIODIC SERVICE
58
ENGLISH
EVERY 1500 HOURS
B
Checking Fuel Injection Nozzle (Injection
Pressure)
Consult your local KUBOTA Dealer for this service.
EVERY 2000 HOURS or EVERY 2 YEARS
Be sure to do the following service once every 2000 hours
or every 2 years whichever comes faster.
B
Flush Cooling System and Changing
Coolant
To avoid serious injury:
A
Do not remove the radiator cap when the
engine is hot. Then loosen cap slightly to the
stop to relieve any excess pressure before
removing cap completely.
1. Stop the engine and let cool down.
2. To drain the coolant, remove the radiator drain plug
and the engine drain plug, and remove the radiator
cap. The radiator cap must be removed to completely
drain the coolant.
3. After all coolant is drained, install the drain plugs.
4. Fill with clean water and cooling system cleaner.
5. Follow directions of the cleaner instruction.
6. After flushing, fill with clean water and anti-freeze until
the coolant level is just below the fill port on the
radiator.
Install the radiator cap securely.
7. Fill with coolant up to "FULL" on the recovery tank.
8. Start and operate the engine for a few minutes.
9. Stop the engine and let cool.
10.Check coolant level of recovery tank and add coolant
if necessary.
A
Do not start engine without coolant.
A
Use clean, distilled water and anti-freeze to fill the
radiator and recovery tank.
A
When mixing the anti-freeze with water, the anti-freeze
mixing ratio is 50%.
A
Securely tighten radiator cap. If the cap is loose or
improperly fitted, water may leak out and the engine
could overheat.
(1) Radiator drain plug
(1) Engine drain plug
(1) Clamp
(2) Recovery tank
(3) Recovery tank cap
(A) "FULL"
(B) "LOW"
