67
PERIODIC SERVICE
ENGLISH
C
Protected circuit
B
Replacing bulbs
(A) Replacement of the headlight bulb
1. Open hood.
2. Turn bulb socket to remove socket from headlight
housing.
3. Push bulb down and turn one quarter turn to remove
bulb from the socket.
4. Install new bulb to the socket.
5. Install the socket in housing.
6. Close hood.
(B) Replacement of the Indicator light bulb
1. Open hood.
2. Turn bad bulb socket to the left.
And remove it.
3. Pull bulb from the socket.
4. Push new bulb into the socket.
5. Install the socket.
6. Close hood.
B
Checking and Replacing Blade
To avoid personal injury:
A
Be sure to stop the engine and remove the key.
A
Blades may be sharp. When you handle blades,
wear heavy gloves or wrap end of blade with a
rag.
C
Checking
The blade cutting edges should be kept sharp at all times.
Sharpen the cutting edges, if they resemble blade (B).
Replace the blades if they appear similar to blade (C).
FUSE NO.
(ID LABEL)
CAPACITY
(A)
Protected circuit
(1)
E/G STOP
15
Engine stop timer relay
IG/M
10
Fuel pump, Head light
Power steering control
unit, etc.
---
3
OPC
(2)
---
Slow blow fuse
40
Check circuit against
wrong battery connection
Headlight bulb
24W
Indicator light bulb
14.0 Rated Voltage/0.27
AMP/2 MSCP
(A) New blade
(B) Worn blade
(C) Cracked blade
Summary of Contents for GR1600-II
