CHECKS BEFORE START
18
B
When the Check-up is Completed
When the check-up is completed, perform the following
procedure to make the Periodic Check disappear from the
screen.
1. The message below appears onscreen to prompt the
completion of the check-up.
2. To take a look at the check points, press the
information switch. The check points appear
onscreen.
3. When the check-up has been completed, press the
switch 5. If not, press the switch 1 to go back to the
previous screen.
B
Horn Switch
B
Light Switch
When the starter switch is in position "RUN", the working
light(s) and CAB light(s) will be switched on by pressing
the switch.
C
Night operation
To avoid personal injury or death:
A
When the working light and CAB light alone do
not provide sufficient visibility, prepare
additional stationary artificial lighting and
observe safety rules for night work.
B
AUX Port Enable Switch
It is possible to freely readjust the actuator's maximum
flow rate in the AUX operating mode.
(See
"AUXILIARY PORT OPERATION"
section for
detail.)
(1) Switch 4
(2) Switch 1
(3) Switch 5
(1) Horn switch
(1) Light switch
(1) AUX port enable switch
Summary of Contents for KX033-4
